The previous owners used a 1/4 inch copper pipe between the sink and the fridge to get drinking water to the cold water dispenser and the icemaker. They hooked into the T-piece at the cold water pipe and ran the pipe in the crawl space under the kitchen floor to the fridge.
Aside from the fact that a break in that pipe caused a little water damage to the old laminate flooring, I also managed to break it more while setting the cabinets. So, out with that stupid whimpy pipe and install a PVC hose like we had in the old house.
I got a 3/8 inch hose (because apparently that's what you are supposed to use with ice makers), the only catch being that all the hookups are 1/4 inch. I got the appropriate adapters at OSH, crawled under the house and found that the heating duct to the dining area had been disconnected when they ran the wires for the sub panel, and not put back together. Fortunately, I had seen the open duct from the entrance to the crawl space, and took some duct tape with me, so I could put it all together again.
Removing the copper pipe and running the PVC hose between the existing holes was easy, if not for the dust under the house. Getting to the kitchen through the crawl space is quite far from the entrance and I had to crawl under heating ducts, and around pipes to eventually get there. I wore a cheapo dust mask, but it didn't help much...
Then it was off to Family Fun Fest at school, a fun afternoon where the students have fun and the parent volunteer to man the various school wide and class specific booths. I did enjoy the hour I was helping to run the rock wall, but got to work in the sun for the full hour. I should look for a tan tomorrow. Probably bright red as usual...
We got back home tired and exhausted from the heat, the people, the noise, the sun, ... brought the kids to bed, and I went back to hooking up the remaining pieces for the water line. Only to find that I couldn't get the fittings tight enough on the hose end, so that not water leaks out. Frustrated I gave up for the evening, went to the garage, ran a couple trains over the layout, and switched Talheim multiple times.
2 comments:
Did you use teflon tape?
I didn't, but will try this morning.
Post a Comment